Typically ships in 3 to 7 business days* Worldwide Free Shipping
Shipping:
Calculated at checkout
Current Stock:
Product Description
Typically ships in 2 to 5 business days* Worldwide Free Shipping Free to the worldwide, if buyer order more than $20,it will be send with tracking number (Insurance).
The transmitter can be either mounted on the camera's hotshoe or connected
to the camera's PC socket with the cord supplied.
Using the PC socket connection (if your camera has one) allows simultaneous
use of a hotshoe-mounted flash unit and off-camera flashes with this radio
trigger set.
There is a test button on the top of the transmitter for test firing. The
dip switches for channel selection are located on the bottom.
There is no power switch. The transmitter uses a small 12V alkaline battery
(the type typically used in garage door opener remotes).
The receiver has a mounting bracket that will fit into a traditional flash
stand, with a 1/4 20 threaded hole for mounting on a light stand or tripod.
An adjusting knob allows the receiver to tilt on the bracket, with detents
at straight up and 45 degree forward and backward positions (It can be tightened
in any position +/- 90 degrees from vertical).
On the top of the receiver is a hotshoe for mounting a flash unit. On the
front of the unit is a small on/off switch and a small LED light that
illuminates briefly when fired. The back of the receiver snaps off to reveal the
battery compartment and two dip switches for channel selection.
It uses two AAA batteries, the type typically used in film cameras. The
battery compartment of the receiver is not clearly marked for polarity, but
there is a faint outline showing the positive tip of the battery on the circuit
board.
Without the bracket and adjusting knob.
Product
Details: weight:140 g size:14.5*8.8*4.5 cm